If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Access VB Help
This is weird! In an Access 2000 VB module, I type in movenext, then press
the F1 Key. I select the DAO library and click on help. I get the message: "An error occured and this feature is no longer functioning properly. Would you like to repair this feature now?" I click on the Yes button and it starts to configure. After a few seconds, I get a blank Microsoft Visual Basic screen. I close it, go back to help, and the same thing happens again. I have already tried uninstalling office twice and the same results occur. Any ideas? Thanks. -- DaveL |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Data Access Page Design | r. howell | General Discussion | 7 | December 12th, 2005 02:16 PM |
Advice needed: Should we upgrade MS Access 2000? And if so to what? | ship | General Discussion | 43 | November 30th, 2005 10:58 PM |
Ambiguous Name Error | pm | Using Forms | 10 | June 5th, 2005 09:19 PM |
2002 vs 2003 | Patrick Stubbin | General Discussion | 2 | May 17th, 2005 07:27 AM |
Access 2000 -vs- Access 2003? | Mark | General Discussion | 5 | November 30th, 2004 06:36 AM |