|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 13th, 2009, 10:14 AM
posted to microsoft.public.access.reports
|
|||
|
|||
How do I change report from portrait to landscape
Hi
I have created a report using the Wizard but I now want to change the orientation of the report from portrait to Landscape. I have searched all the property fields and I can't see where I can do this. Is it possible nd if so, how can I do it? Thanks Malcolm 
|
|
#2
October 13th, 2009, 11:43 AM
posted to microsoft.public.access.reports
|
|||
|
|||
|
How do I change report from portrait to landscape
Click on File, then Page Setup.
You should pick up the option from there. "malycom" wrote in message ... Hi I have created a report using the Wizard but I now want to change the orientation of the report from portrait to Landscape. I have searched all the property fields and I can't see where I can do this. Is it possible nd if so, how can I do it? Thanks Malcolm
|
|
#3
October 13th, 2009, 11:55 AM
posted to microsoft.public.access.reports
|
|||
|
|||
|
How do I change report from portrait to landscape
Thanks Simeon
I really over complicated that. I don't know why I didn't try to look there in the first place. To busy looking at the actual report properties. Thanks "SimeonD" wrote: Click on File, then Page Setup. You should pick up the option from there. "malycom" wrote in message ... Hi I have created a report using the Wizard but I now want to change the orientation of the report from portrait to Landscape. I have searched all the property fields and I can't see where I can do this. Is it possible nd if so, how can I do it? Thanks Malcolm
|
|
#4
October 13th, 2009, 03:49 PM
posted to microsoft.public.access.reports
|
|||
|
|||
|
How do I change report from portrait to landscape
Now that you say it, it is strange that it isn't a property. After all,
everything else is. Glad to help. Simeon "malycom" wrote in message ... Thanks Simeon I really over complicated that. I don't know why I didn't try to look there in the first place. To busy looking at the actual report properties. Thanks "SimeonD" wrote: Click on File, then Page Setup. You should pick up the option from there. "malycom" wrote in message ... Hi I have created a report using the Wizard but I now want to change the orientation of the report from portrait to Landscape. I have searched all the property fields and I can't see where I can do this. Is it possible nd if so, how can I do it? Thanks Malcolm
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
