If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do I change incoming mail to read in HTML format?
Outlook 2000
Incoming mail should read in HTML format, but all incoming HTML mail "converts" to plain text. What settings do I change? I assume I have changed the obvious. |
#2
|
|||
|
|||
Check the format of the mail you receive.
Then check your settings in Tools - Options, Mail Format "shultz" wrote in message ... Outlook 2000 Incoming mail should read in HTML format, but all incoming HTML mail "converts" to plain text. What settings do I change? I assume I have changed the obvious. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Change the default email form to 1 I've created as a .oft form? | liteparts | General Discussion | 1 | May 11th, 2005 08:06 PM |
Ms-Access 2003 | RC | General Discussion | 23 | January 19th, 2005 08:22 PM |
Trigger event on change to unbound text in unbound form programmat | AbeR | Using Forms | 5 | January 6th, 2005 07:33 PM |
how can I change data file locations for html mail accounts | sticks99 | Installation & Setup | 2 | September 16th, 2004 03:35 PM |