If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Vertical line width on report
I have got vertical lines in my reports where I want them using me.line
method. Print Preview looks good, exactly as I wanted, but when I actually print, the lines are extremely faint, barely noticeable even. Is there any way to increase the width or make the lines thicker? |
#2
|
|||
|
|||
Vertical line width on report
Check the BorderWidth property.
-- Doug Steele, Microsoft Access MVP http://www.AccessMVP.com/DJSteele (no e-mails, please!) "Robbro" wrote in message ... I have got vertical lines in my reports where I want them using me.line method. Print Preview looks good, exactly as I wanted, but when I actually print, the lines are extremely faint, barely noticeable even. Is there any way to increase the width or make the lines thicker? |
#3
|
|||
|
|||
Vertical line width on report
=?Utf-8?B?Um9iYnJv?= wrote in
: I have got vertical lines in my reports where I want them using me.line method. Print Preview looks good, exactly as I wanted, but when I actually print, the lines are extremely faint, barely noticeable even. Is there any way to increase the width or make the lines thicker? before issuing the draw statements, set Me.DrawWidth = pixels -- Bob Quintal PA is y I've altered my email address. |
Thread Tools | |
Display Modes | |
|
|