If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Report Formatting - Headers
Hi,
I have a report that prints out specs hardware items grouped by hardware type. The Hardware type has it's own header. What I want to do is be able to set up a report that from page 2 onwards displays a page header stating the 'hardware type' carrying over from the previous page. I don't want to have to put each type on a seperate page. thanks in advance nick |
#2
|
|||
|
|||
Open your report in design view.
Right-click the Hardware Type Header section, and choose Properties. Set the Repeat Section property to Yes. The section will then repeat at the top of each subsequent page. -- Allen Browne - Microsoft MVP. Perth, Western Australia. Tips for Access users - http://allenbrowne.com/tips.html Reply to group, rather than allenbrowne at mvps dot org. "Nick in Tokyo" wrote in message ... I have a report that prints out specs hardware items grouped by hardware type. The Hardware type has it's own header. What I want to do is be able to set up a report that from page 2 onwards displays a page header stating the 'hardware type' carrying over from the previous page. I don't want to have to put each type on a seperate page. thanks in advance nick |
#3
|
|||
|
|||
Thanks very much!
"Allen Browne" wrote: Open your report in design view. Right-click the Hardware Type Header section, and choose Properties. Set the Repeat Section property to Yes. The section will then repeat at the top of each subsequent page. -- Allen Browne - Microsoft MVP. Perth, Western Australia. Tips for Access users - http://allenbrowne.com/tips.html Reply to group, rather than allenbrowne at mvps dot org. "Nick in Tokyo" wrote in message ... I have a report that prints out specs hardware items grouped by hardware type. The Hardware type has it's own header. What I want to do is be able to set up a report that from page 2 onwards displays a page header stating the 'hardware type' carrying over from the previous page. I don't want to have to put each type on a seperate page. thanks in advance nick |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Formatting a report based on checkboxes | Amit | Setting Up & Running Reports | 4 | August 12th, 2004 06:10 PM |
Label | SRIT | General Discussion | 2 | June 22nd, 2004 09:42 PM |
How to print an Access Report multiple times, w/ different headers | Dave Corun | Setting Up & Running Reports | 3 | June 2nd, 2004 02:31 AM |