If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Booklet printing/margin problems
A small child turns to Ed, and exclaims: "Look! Look! A post from Don
Schmidt Retired !"... Here in the colonies the most common sizes a 8˝"x11" 8˝"x14" 11"x17" = would be used for a booklet size 8˝"x11" I believe it's an oversized size - for full bleed printing without the extra equipment. A bit like A3+ -- Ed Bennett - MVP Microsoft Publisher http://www.mvps.org/the_nerd/ Before reading this message, view the disclaimer: http://mvps.org/the_nerd/disclaim.htm |
#12
|
|||
|
|||
Booklet printing/margin problems
|
#13
|
|||
|
|||
Booklet printing/margin problems
Jon there are no issues whatsoever with Publisher and page sizes and never has been.
Nothing is a non-standard size in Publisher, all you have to do is have a printer driver installed that supports that size. You may also want to look at Serif PagePlus which does not require you to have a printer driver installed that supports the page size. All the regulars here use PagePlus as well as Publisher. -- "If you don't know where you are going, any road will take you there!" |
|
Thread Tools | |
Display Modes | |
|
|