After Installation

#1 September 14th, 2004, 09:52 PM

I have done the basic installation on office 2003. I have
been running the program for a while. I should have
installed it to have set up everything at one time
instead of when I use it. Is there a way to overwrite
that and install everything at one time now that I have
been using it and I have information in office programs?

#2 September 14th, 2004, 10:27 PM

TJ,
Goto the control panel/add or remove programs then look for office.
Highlight it then pick change, it will look as if office is installing
again. from there you can add or take components of office you do not want.
From here you should pick run all from my computer. Do this with the cd in
the tray and it will add in the missing features or components
"tj945" wrote in message
...
I have done the basic installation on office 2003. I have
been running the program for a while. I should have
installed it to have set up everything at one time
instead of when I use it. Is there a way to overwrite
that and install everything at one time now that I have
been using it and I have information in office programs?

Thread Tools
Show Printable Version Email this Page
Display Modes
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Error 1706	Sayisangu	Setup, Installing & Configuration	2	January 11th, 2005 10:16 PM
Office XP Installation	Deb K	Setup, Installing & Configuration	4	September 16th, 2004 02:02 PM
Productkey problem when installing office 2003 on network	Stefan Schreurs	Setup, Installing & Configuration	1	June 1st, 2004 11:16 PM
Office 2003 deployment w/o volume key	Ulrich Wurst	Setup, Installing & Configuration	2	May 19th, 2004 06:39 PM
Installation of Office 2000 under a domain	BJM	Setup, Installing & Configuration	0	April 28th, 2004 09:55 PM