If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
After Installation
I have done the basic installation on office 2003. I have
been running the program for a while. I should have installed it to have set up everything at one time instead of when I use it. Is there a way to overwrite that and install everything at one time now that I have been using it and I have information in office programs? |
#2
|
|||
|
|||
TJ,
Goto the control panel/add or remove programs then look for office. Highlight it then pick change, it will look as if office is installing again. from there you can add or take components of office you do not want. From here you should pick run all from my computer. Do this with the cd in the tray and it will add in the missing features or components "tj945" wrote in message ... I have done the basic installation on office 2003. I have been running the program for a while. I should have installed it to have set up everything at one time instead of when I use it. Is there a way to overwrite that and install everything at one time now that I have been using it and I have information in office programs? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Error 1706 | Sayisangu | Setup, Installing & Configuration | 2 | January 11th, 2005 10:16 PM |
Office XP Installation | Deb K | Setup, Installing & Configuration | 4 | September 16th, 2004 02:02 PM |
Productkey problem when installing office 2003 on network | Stefan Schreurs | Setup, Installing & Configuration | 1 | June 1st, 2004 11:16 PM |
Office 2003 deployment w/o volume key | Ulrich Wurst | Setup, Installing & Configuration | 2 | May 19th, 2004 06:39 PM |
Installation of Office 2000 under a domain | BJM | Setup, Installing & Configuration | 0 | April 28th, 2004 09:55 PM |