|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 24th, 2005, 03:47 PM
|
|||
|
|||
IF function... not equal to
How do I set the IF function to do a "not equal to" or "does not equal" or
something similar? As opposed to =, , , =, =. 
|
|
#2
March 24th, 2005, 08:35 PM
|
|||
|
|||
|
You can also go ahead and use =, just reverse your true/false arguments...
_usually_ |:) "cj_singer" wrote: How do I set the IF function to do a "not equal to" or "does not equal" or something similar? As opposed to =, , , =, =.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Hi - RPC over HTTP problem: | MarkInIreland | Installation & Setup | 3 | March 13th, 2005 02:29 PM |
| Hyperlinks using R[1]C[1] and offset function in its cell referenc | Elijah-Dadda | Worksheet Functions | 0 | March 5th, 2005 03:31 AM |
| OLE Object- the real question | Michelle | Using Forms | 18 | February 28th, 2005 04:04 AM |
| Can you limit TopValue function when values are equal? | confused | Running & Setting Up Queries | 1 | October 8th, 2004 06:58 AM |
| #Error using function as controlsource | Laurel | New Users | 4 | September 24th, 2004 08:31 PM |
Linear Mode
