If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Printing a report 2-up
How do I go about creating a report that retrieves data from my table and
produces a report of that data 2-up (side by side). ! record on the left and the next record on the right? -- Thank you for your help. |
#2
|
|||
|
|||
Printing a report 2-up
You can do it with a snaking columns report that goes across then down.
Steve "Bill" wrote in message ... How do I go about creating a report that retrieves data from my table and produces a report of that data 2-up (side by side). ! record on the left and the next record on the right? -- Thank you for your help. |
#3
|
|||
|
|||
Printing a report 2-up
How do I do that? For instance I have fields Name, Check, Amount, Paid by.
Whne I add these fields to my report they automatically go horizontality. What do I do to make the 2nd record "snake"? etc. -- Thank you for your help. "Steve" wrote: You can do it with a snaking columns report that goes across then down. Steve "Bill" wrote in message ... How do I go about creating a report that retrieves data from my table and produces a report of that data 2-up (side by side). ! record on the left and the next record on the right? -- Thank you for your help. . |
#4
|
|||
|
|||
Printing a report 2-up
Open your report in design view
In Access 2003 and earlier SELECT File: Page Setup from the menu Click on the Columns tab Change Number of Columns to 2 Change Column Size Width to a value that is half the width minus your margins and column spacing. Change Column layout to Across then Down You can do a similar thing in Access 2007 and 2010. You will just have to find how to get into Page Setup when using the Ribbon. John Spencer Access MVP 2002-2005, 2007-2010 The Hilltop Institute University of Maryland Baltimore County Bill wrote: How do I do that? For instance I have fields Name, Check, Amount, Paid by. Whne I add these fields to my report they automatically go horizontality. What do I do to make the 2nd record "snake"? etc. |
Thread Tools | |
Display Modes | |
|
|