If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Can a Table be opened in datasheet view from a form
Trying to figure out how to open a table in datasheet view using a control
button on a form and not use a split form view. Any help? |
#2
|
|||
|
|||
Can a Table be opened in datasheet view from a form
On Mon, 1 Feb 2010 13:00:01 -0800, ksgolfer wrote:
Trying to figure out how to open a table in datasheet view using a control button on a form and not use a split form view. Any help? I'll assume you meant to say "open a 'form' in datesheet view". To open a form in datasheet view by means of code you must explicitly code it to open in datasheet view: DoCmd.OpenForm "FormName", acFormDS -- Fred Please respond only to this newsgroup. I do not reply to personal e-mail |
Thread Tools | |
Display Modes | |
|
|