If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Off Page Connector Does Not Work.
I have created a data flow diagram and at the bottom of each page, I put an
off page connector to jump to the next page. So page 1 has a connector that jumps to page 2, page 2 has a connector that jumps to page 3 and so on. I had accidentally created a duplicate page 3, so page 3 and 4 were the same. I deleted page 4 and renamed page 5 to page 4. I then deleted the off page connector on page 3 and add a new OPC to page 3 to jump to page 4. That OPC does not work when I double click on it. It just stays on page 3. What did I do wrong. -- Tom |
#2
|
|||
|
|||
Off Page Connector Does Not Work.
Hello Tom,
You'll need to delete you off page connectors and add them again as I guess the existing ones (or at least some) are pointing to pages and shapes that aren't there. The OPC addon generates GUIDs, which are unique IDs, when the shape is dropped onto a page so that each connector shape knows what shape and on what page it has to navigate to. If you're interested you can have a look at this thread which talks about accessing these via code: http://www.microsoft.com/communities...b-29f0385a29f4 Unless you have a lot of pages then I would just replace them manually. Hope that helps. Best regards John John Goldsmith (Visio MVP) www.visualSignals.typepad.co.uk www.visualSignals.co.uk "Tom" wrote in message ... I have created a data flow diagram and at the bottom of each page, I put an off page connector to jump to the next page. So page 1 has a connector that jumps to page 2, page 2 has a connector that jumps to page 3 and so on. I had accidentally created a duplicate page 3, so page 3 and 4 were the same. I deleted page 4 and renamed page 5 to page 4. I then deleted the off page connector on page 3 and add a new OPC to page 3 to jump to page 4. That OPC does not work when I double click on it. It just stays on page 3. What did I do wrong. -- Tom |
Thread Tools | |
Display Modes | |
|
|