If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Printing part of a double side document as a book, part as a table
I have a long report which needs to be printed double sided. Within the
report is a large table in landscape view (the rest of the report is portrait). For easy reading, I want the landscape pages of the document printed in a 'tablet' rather than 'book' style. Is this possible? |
#2
|
|||
|
|||
Printing part of a double side document as a book, part as a table
I think your only recourse is to print the landscape section separately,
changing the duplex setting of the printer between runs. Note, however, that flipping on the long edge (as for the portrait pages) should give the desired result, allowing tables to be read continuously from the left edge of the left-hand page (top) to the right edge of the right-hand page (bottom). -- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA http://word.mvps.org "hippo83" wrote in message ... I have a long report which needs to be printed double sided. Within the report is a large table in landscape view (the rest of the report is portrait). For easy reading, I want the landscape pages of the document printed in a 'tablet' rather than 'book' style. Is this possible? |
Thread Tools | |
Display Modes | |
|
|