If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Disable all form events?
Hi all,
One of my applications is used by several users, mainly through terminal sessions. One of the drawbacks with this is (sometimes) the slow response time. This causes the user to click on buttons again after initial clicking. E.g. from a swichboard form, if the users clicks a button to open another form, and this form is not opened as quickly as expected, the user tries again. This results in opening the form twice, with all corresponding problems and errors. The same is when closing the form. Using the "close" event, data is collected, manipulated and stored. If this button is used twice, again we may get problems and errors. So my question is: is there an easy way to prevent this? Of course I can disable a control/button after initial use, but I do not know if this is the best solution. In the switchboard form, there are about 10 options. And disabling all these options separately (and afterward enabling again) is not my preferred solution. Can I disable all form events with one command, or postpone/ignore any input during processing? Thinks in advance for any suggestions. Paul |
Thread Tools | |
Display Modes | |
|
|