|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
April 23rd, 2010, 06:44 AM
posted to microsoft.public.access.gettingstarted
|
|||
|
|||
open report
Hi
Is it possible to make a label visible during the OpenReport command? I have the following commands: If option 1 is selected -- DoCmd.OpenReport stDocName, acPreview, , "M1Ass1Comment='Fail M1Ass1'" If option 2 is selected - DoCmd.OpenReport stDocName, acPreview, , "M1Ass2Comment='Fail M1Ass2'" , etc However, I would like a different label on the report to be visible depending on the selection. Is On Load the only way to achieve that? Thank you Kary -- Message posted via AccessMonster.com http://www.accessmonster.com/Uwe/For...arted/201004/1 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode