|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
February 14th, 2007, 04:43 PM
posted to microsoft.public.access.queries
|
|||
|
|||
Queries with Parameters
Is there a way to have a 2 queries with a parameter input and then have a 3rd
call these queries selecting everything and unioning them together somehow passing in a parameter from the 3rd query back to the two it is calling? 
|
|
#2
February 14th, 2007, 06:44 PM
posted to microsoft.public.access.queries
|
|||
|
|||
|
Queries with Parameters
Dale wrote:
Is there a way to have a 2 queries with a parameter input and then have a 3rd call these queries selecting everything and unioning them together somehow passing in a parameter from the 3rd query back to the two it is calling? Use a macro. K Board -- Message posted via AccessMonster.com http://www.accessmonster.com/Uwe/For...eries/200702/1
|
|
#3
February 14th, 2007, 11:57 PM
posted to microsoft.public.access.queries
|
|||
|
|||
|
Queries with Parameters
If you have a third query using two other parameter queries then simply
running the third query will cause the parameters to be requested. If I have misunderstood what you are asking, I apologize. '================================================= === John Spencer Access MVP 2002-2005, 2007 Center for Health Program Development and Management University of Maryland Baltimore County '================================================= === Dale wrote: Is there a way to have a 2 queries with a parameter input and then have a 3rd call these queries selecting everything and unioning them together somehow passing in a parameter from the 3rd query back to the two it is calling?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
