If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Create chart using part of data table (data legend)
Hi I want to create a chart use only a part of data table (data legend) but I
want the data table (data legend) to show all data. Because data is too much I just want the chart to show only two of them but I want to see the other data values on the data table. Is that possible ?? |
Thread Tools | |
Display Modes | |
|
|