If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
MS 2003: Table at 100% does not resize properly
I've never had this happen before.
A table with Table PropertiesPreferred width... set to 100% in a single column (7") page does not reset to 100% of the column width when the page format is changed to two columns (2" and 5"). Instead the table displays as slightly more than half of the 5" column (approximately 3"), although Table PropertiesPreferred width... still says 100%. Any ideas? |
Thread Tools | |
Display Modes | |
|
|