If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Row height problem
I'm trying to make a table to match a sheet of precut labels. they are 1"
wide and 2" high and there are 40 on a sheet. I haven't found a template for them on the web. My table works quite well except that, when printed, the height of each row increases a little as you go down the sheet. This results in the last row being out of sync with the labels by about 1/8". I have the row height set for 2" exactly, but this dosen't seem to do the job. I would appreciate any suggestions or, if some one can point me to a tempelate by Avery or others, that would be great. Thanks, Jim Birke |
#2
|
|||
|
|||
Row height problem
Here's a link to Avery's label templates:
http://www.avery.com/avery/en_us/Templates-&-Software -- Krystyne "JimB" wrote: I'm trying to make a table to match a sheet of precut labels. they are 1" wide and 2" high and there are 40 on a sheet. I haven't found a template for them on the web. My table works quite well except that, when printed, the height of each row increases a little as you go down the sheet. This results in the last row being out of sync with the labels by about 1/8". I have the row height set for 2" exactly, but this dosen't seem to do the job. I would appreciate any suggestions or, if some one can point me to a tempelate by Avery or others, that would be great. Thanks, Jim Birke |
#3
|
|||
|
|||
Row height problem
Assuming that you have set up the table with dimensions that match those of
the label, the problem is probably that your printer is not capable of accurately handling the label stock. If you print to a plain sheet of paper, is everything then aligned correctly (or more correctly) Inability to accurately handle label stock is a common occurence with low-end ink-jet printers. -- Hope this helps. Please reply to the newsgroup unless you wish to avail yourself of my services on a paid consulting basis. Doug Robbins - Word MVP "JimB" wrote in message ... I'm trying to make a table to match a sheet of precut labels. they are 1" wide and 2" high and there are 40 on a sheet. I haven't found a template for them on the web. My table works quite well except that, when printed, the height of each row increases a little as you go down the sheet. This results in the last row being out of sync with the labels by about 1/8". I have the row height set for 2" exactly, but this dosen't seem to do the job. I would appreciate any suggestions or, if some one can point me to a tempelate by Avery or others, that would be great. Thanks, Jim Birke |
Thread Tools | |
Display Modes | |
|
|