|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 26th, 2004, 03:25 PM
|
|||
|
|||
Change default measurement in Visio from metric to imperial
Change default measurement in Visio from metric to imperial
|
|
#2
November 28th, 2004, 04:56 AM
|
|||
|
|||
|
File Page Setup Page Properties.
-- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "syls" wrote in message ... Change default measurement in Visio from metric to imperial
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How do I change default behaviors in Visio? | RWilliams | Visio | 0 | November 2nd, 2004 10:56 PM |
| metric vs. imperial | Marco B. | Setup, Installing & Configuration | 1 | September 30th, 2004 06:48 AM |
| Cannot change default format of new mail messages | Bill Bailey | General Discussion | 3 | August 28th, 2004 05:29 PM |
| Change default calendar folder | Andrew | Calendar | 4 | July 17th, 2004 06:37 PM |
| Default File Location | Derek Ruesch | Setting up and Configuration | 6 | January 30th, 2004 03:03 AM |
Linear Mode
