If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Shapes fall to the bottom of the page
Using Visio 2000 I am making Cross-Functional flow charts, typically with 5
to 7 horizontal bands, several sheets to a file. At times, after I have saved a diagram, when I open it again all the shapes and connectors appear to have fallen to the bottom of the page. The shapes are flattened, but the text is not. I would like for my shapes to stay put! Any assistance will be greatly appreciated. |
#2
|
|||
|
|||
Hello, several of my colleagues are encountering the same problem, but not
myself. Have you received an answer to this problem yet? "jpeter930" wrote: Using Visio 2000 I am making Cross-Functional flow charts, typically with 5 to 7 horizontal bands, several sheets to a file. At times, after I have saved a diagram, when I open it again all the shapes and connectors appear to have fallen to the bottom of the page. The shapes are flattened, but the text is not. I would like for my shapes to stay put! Any assistance will be greatly appreciated. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Report Margin | Irshad Alam | Setting Up & Running Reports | 1 | August 15th, 2004 07:17 PM |
Headers and Footers | Pat Jennings | Page Layout | 9 | July 29th, 2004 07:39 PM |
Bookfold - Positioning Pages on the Sheet of Paper | Bill B. | Page Layout | 6 | June 29th, 2004 09:26 AM |
NUMBERING the pages | Bob | New Users | 7 | June 14th, 2004 12:20 AM |
Incorrect {PAGE} fields in document compiled with VBA from others docs | Ganeth | General Discussion | 1 | June 2nd, 2004 10:51 AM |