If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Diagram re-arranged upon re-opening file
Using the cross-functional horizontal: shapes and connectors are placed with
no problem and the file saved. Upon re-opening, all the shapes are at the bottom of the chart. Help! |
#2
|
|||
|
|||
Make sure you have installed the latest service packs for your version of
Visio. I believe this issue has been corrected. -- Mark Nelson Microsoft Corporation This posting is provided "AS IS" with no warranties, and confers no rights. "Lana" wrote in message ... Using the cross-functional horizontal: shapes and connectors are placed with no problem and the file saved. Upon re-opening, all the shapes are at the bottom of the chart. Help! |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
You do not have exclusive access... ERROR | Robin | General Discussion | 1 | July 6th, 2004 01:18 AM |
Application must be installed to run Error | Keith | Setup, Installing & Configuration | 1 | June 29th, 2004 03:02 AM |
Getting source lists w/o opening target file | Arifi Koseoglu | Links and Linking | 5 | May 25th, 2004 05:55 PM |
Word opening the WRONG normal.dot file | Harry Hudini | Page Layout | 9 | May 1st, 2004 01:12 PM |
problem opening .csv file | Karen | Setting up and Configuration | 0 | September 19th, 2003 02:23 AM |