If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
!
HI there, I get an exclamation mark everytime I copy and paste formulas. Then
to remove it I click in the ! and select ignore. I need to do this many many times. Is there any trick to do it all at once. I have tried to select big areas but then the exclamation mark hides. Thanks,jose |
#2
|
|||
|
|||
!
The exclamation mark (in a yellow diamond) is an indication that automatic
(possible) error checking has detected a condition that may cause you a problem. You can globally stop checking for particular errors by going to Tools | Options | and on the [Error Checking] tab, clear the errors you don't want it to check for. In 2007 there is an "Error Checking Options" choice in the list shown when you click the warning which takes you to the same place in 2007. "Joe" wrote: HI there, I get an exclamation mark everytime I copy and paste formulas. Then to remove it I click in the ! and select ignore. I need to do this many many times. Is there any trick to do it all at once. I have tried to select big areas but then the exclamation mark hides. Thanks,jose |
Thread Tools | |
Display Modes | |
|
|