If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How can I enable the Protect Form icon on a DOT file I created?
I have created a few *.dot file that include Text Fields" and have protected
them by using the "Protect Form" icon. When I open the *.dot file to make a change, I can't seem to unprotect the form to make change or when it for some reason it let's me & I can make change, then the "Protect Form" icon is disabled so I can't protect it. I must ne missing something!? -help? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Linking v Embedded | Jim Bunton | General Discussion | 5 | August 10th, 2005 11:09 PM |
OLE Object- the real question | Michelle | Using Forms | 18 | February 28th, 2005 04:04 AM |
Office 2003 uninstall/reinstall problems | Jerryn3 | Setup, Installing & Configuration | 2 | August 2nd, 2004 03:39 PM |
You do not have exclusive access... ERROR | Robin | General Discussion | 1 | July 6th, 2004 01:18 AM |
Unsafe Attachments | Ron | Installation & Setup | 2 | June 9th, 2004 01:55 AM |