If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Two page forms and page breaks
At work, I was asked to lengthen a form to two pages. I inserted a page break
and rearranged the fields to fit the two pages. When the form opened, via the switchboard, I could only see the header of the first page and the entire second page. I was unable to access the first page of the form to enter data. I would appreciate some help on this. I think they are using Access 97 still. I'm still new to Access so take it easy on me, ok? |
#2
|
|||
|
|||
Two page forms and page breaks
Where did you put your page break; in the header, body, or footer of the form?
"2old2stayout" wrote: At work, I was asked to lengthen a form to two pages. I inserted a page break and rearranged the fields to fit the two pages. When the form opened, via the switchboard, I could only see the header of the first page and the entire second page. I was unable to access the first page of the form to enter data. I would appreciate some help on this. I think they are using Access 97 still. I'm still new to Access so take it easy on me, ok? |
#3
|
|||
|
|||
Two page forms and page breaks
2old2stayout wrote:
At work, I was asked to lengthen a form to two pages. I inserted a page break and rearranged the fields to fit the two pages. When the form opened, via the switchboard, I could only see the header of the first page and the entire second page. I was unable to access the first page of the form to enter data. I would appreciate some help on this. I think they are using Access 97 still. I'm still new to Access so take it easy on me, ok? Page breaks in forms is rather out-dated. I would suggest you use the TabControl with two TabPages instead. -- I don't check the Email account attached to this message. Send instead to... RBrandt at Hunter dot com |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Report with set number of rows per page | Ken from Chicago | Running & Setting Up Queries | 7 | January 4th, 2006 02:42 PM |
Report with set number of rows per page | Ken from Chicago | Setting Up & Running Reports | 7 | January 4th, 2006 02:42 PM |
Report with set number of rows per page | Ken from Chicago | General Discussion | 7 | January 4th, 2006 02:42 PM |
Controlling page breaks in Access 2003 Forms | claruspaw | General Discussion | 12 | April 17th, 2005 12:52 PM |