|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 1st, 2004, 02:54 PM
|
|||
|
|||
Page width/length error opening a Word 2000 file in 2003
I just installed Professional 2003. Now (some- not all)
Word Documents created earlier in Word 2000 layout differently when the file is opened. (even though the page is set to 8.5x11, the print layout leaves a big margin at the right and bottom- effectively shrinking the whole page.) Any ideas? (Just as a note- the file does have text in different fonts and text boxes if that makes a difference.) -HJD 
|
|
#2
May 1st, 2004, 06:17 PM
|
|||
|
|||
|
Page width/length error opening a Word 2000 file in 2003
False alarm- I figured out that I was in View Markup
mode, so comments in the document were pushing the print layout over. OK now. -HJD -----Original Message----- I just installed Professional 2003. Now (some- not all) Word Documents created earlier in Word 2000 layout differently when the file is opened. (even though the page is set to 8.5x11, the print layout leaves a big margin at the right and bottom- effectively shrinking the whole page.) Any ideas? (Just as a note- the file does have text in different fonts and text boxes if that makes a difference.) -HJD .
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
