If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
error message:An error has occurred"
Okay, a couple of times today i wasn;t able to read my emails in the
reading pane, receive new emails, see my contacts list. However, if I try to fully open an email or reply to an email or create a new email I get the following, compltetely unhelpful and useless, error message: "There was an error opening this message An error has occurred" Which, obviously tells me NOTHING about what the problem is so I have no clue how to even begin tying to sort it out. Anyone got any ideas or hints or tips for me? plz |
#2
|
|||
|
|||
error message:An error has occurred"
Err Msg: The Message Could Not Be Sent. Some recipients not valid
(Outlook Express: There was an error opening this message) (The Address Book failed to load. OE is incorrectly configured) (Corrupted or mismatched WAB32.DLL file) http://support.microsoft.com/?kbid=239135 OLEXP: Error Message: Address Book Failed to Load (There was an error opening this message) http://support.microsoft.com/?kbid=269777 http://support.microsoft.com/?kbid=310873 OLEXP: MSIMN Caused an Invalid Page Fault in Module Wab32.dll http://support.microsoft.com/?kbid=247706 Err Msg: Address Book Failed To Load, Outlook Express Is... http://support.microsoft.com/?kbid=191946 Err Msg: Unable to Open Address Book, a Component Is Missing http://support.microsoft.com/?kbid=192321 -- Mike - http://pages.prodigy.net/michael_santovec/techhelp.htm wrote in message ... Okay, a couple of times today i wasn;t able to read my emails in the reading pane, receive new emails, see my contacts list. However, if I try to fully open an email or reply to an email or create a new email I get the following, compltetely unhelpful and useless, error message: "There was an error opening this message An error has occurred" Which, obviously tells me NOTHING about what the problem is so I have no clue how to even begin tying to sort it out. Anyone got any ideas or hints or tips for me? plz |
Thread Tools | |
Display Modes | |
|
|