If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Unwanted blank page
I have a report header that I want to print on a
page by itself. I've set the report properties so that there's no page header or page footer and so the report header page prints properly. However, I can't find what is causing a blank page to come out before the report header page. What might have done to cause the blank page? Thanks, Bill |
#2
|
|||
|
|||
Unwanted blank page
Just needed to tweak the report-header height
versus the report page setup... I thought that was okay to begin with, but I had to make the overall height of the report header a couple of tenths less than what one would normally expect. Namely topmar + botmar + hdrheight = pageheight. Bill "Bill" wrote in message k.net... I have a report header that I want to print on a page by itself. I've set the report properties so that there's no page header or page footer and so the report header page prints properly. However, I can't find what is causing a blank page to come out before the report header page. What might have done to cause the blank page? Thanks, Bill |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
No page #s appear on 1st 2 pgs after section split in Pub2K3 | GPSIS | Publisher | 9 | November 15th, 2005 08:35 PM |
Auto numbering | store5064 | General Discussions | 11 | June 2nd, 2005 08:38 PM |
Creating an "unmovable" blank page | Dan | Page Layout | 1 | October 11th, 2004 11:12 PM |
Label | SRIT | General Discussion | 2 | June 22nd, 2004 09:42 PM |
How to delete a blank page between the pages. | Suzanne S. Barnhill | General Discussion | 2 | May 17th, 2004 11:06 AM |