If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Synchronizing subforms
Hello,
Finally my office has upgraded to MS Access 2007. Now, I am having a bit of a problem synchronizing subforms on a tab. Let me begin with what I have set up; then explain my two objectives. On a particular tab, I have: The first subform created from a query in a datasheet view. The query is based on a table consisting of many employees with respective personnel ID numbers (PersID). Let's call it Subform1. Subform1 contains a combo list with a select of a PersID (Long Integer). The Control Source = PersID and the Row Source = the selection of the PersID from the query. Upon selection the remaining associated fields fill in the record line. In essence, I may have 100 employees in the table, but select three to five employees from the query in the subform. The second subform is created from the same query in a single form view. It refelcts the single form view of the same records as Subform 1. Objectives: Objective 1: After selecting a record from Subform1, I need Subform2 to reflect the same record. At present, after adding a new record in Subform1, the new record does not appear in Subform2, in fact the expected record is blank. I must close and reopen the tab so that the new record will appear in Subform2. Objective: I need the next record to appear after selecting a new record in Subform1. Objective 2: Whenever the focus is on a particular record in Subform1 (let's say I simply click the field of the PersID without selecting a record, or for that matter simply click on the employee's last name field, I would like the associated single form view in Subform2 to reflect the associated record from Subform1. The event doesn't matter whether it is a focus or click of a mouse on any particular field of a record in Subform1. Back in Access 2003, I was able to do this by opening a separate form without using tabs by employing a macro that synchronized the two forms and incorporated an On Current condition to synchronize the two form. But with Access 2007, I am a bit confused. Any assistance will be greatly appreciated. Thanks, Scotty -- Message posted via AccessMonster.com http://www.accessmonster.com/Uwe/For...forms/201002/1 |
Thread Tools | |
Display Modes | |
|
|