If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Startup display form always maximized
Is there a setting that will allow me to specify that the startup form be
displayed in it's native size, not maximized within the Access MDI window? |
#2
|
|||
|
|||
Startup display form always maximized
Set the startup form to it's native size by clicking the restore button in
design view, then save the form. Jeanette Cunningham MS Access MVP -- Melbourne Victoria Australia "slindee" wrote in message ... Is there a setting that will allow me to specify that the startup form be displayed in it's native size, not maximized within the Access MDI window? |
#3
|
|||
|
|||
Startup display form always maximized
Add the code DoCmd.Maximize
"Jeanette Cunningham" wrote: Set the startup form to it's native size by clicking the restore button in design view, then save the form. Jeanette Cunningham MS Access MVP -- Melbourne Victoria Australia "slindee" wrote in message ... Is there a setting that will allow me to specify that the startup form be displayed in it's native size, not maximized within the Access MDI window? . |
#4
|
|||
|
|||
Startup display form always maximized
In the startup forms Activate event, place the following:
docmd.restore "slindee" wrote: Is there a setting that will allow me to specify that the startup form be displayed in it's native size, not maximized within the Access MDI window? |
Thread Tools | |
Display Modes | |
|
|