If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
using VBA to determine which page a subreport is currently on
Hello,
within the detail_format() function can VBA determine which page the sub-report is currently on? thanks |
#2
|
|||
|
|||
using VBA to determine which page a subreport is currently on
You can try (untested) code like:
Me.Parent.Report.Page to get the parent page. You might need a control on the main report bound to [Page]. -- Duane Hookom MS Access MVP -- "a" wrote in message ... Hello, within the detail_format() function can VBA determine which page the sub-report is currently on? thanks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Changing page number | Denis Levesque | General Discussion | 4 | April 11th, 2006 12:58 PM |
Want to start page 1 numbering after five pages - how? | RM | Page Layout | 6 | April 5th, 2006 05:07 AM |
Page Numbers | Aurora | General Discussion | 0 | November 17th, 2005 08:04 PM |
No page #s appear on 1st 2 pgs after section split in Pub2K3 | GPSIS | Publisher | 9 | November 15th, 2005 08:35 PM |
NEED TO DETERMINE SUBREPORT NAME BEING PRINTED WHEN PAGE BEGINS | tenap | Setting Up & Running Reports | 1 | August 29th, 2005 12:21 PM |