If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Access 97 label printing problem
I am trying to print 3-up labels from a table of
addresses. My entire data base was copied from my old system and all other functions are working normal. I have added to the address table with no problems--it has 1150 addresses in it. When I try to print labels, I am ask to "enter parameter value" for "trim". This request has not been asked previously. No matter what value keyed to this request, I receive a listing in 3-up label format of # ERROR for each line of each label. I have also used the label wizard to redo this report, but the results are the same. Another attempt using a Query as input for the report yeilds the same problem. I need expert help for this problem. Thanks for your experience |
#2
|
|||
|
|||
This is a references issue. Check Doug Steele's page at
http://members.rogers.com/douglas.j....nceErrors.html. -- Duane Hookom MS Access MVP "Glenn" wrote in message ... I am trying to print 3-up labels from a table of addresses. My entire data base was copied from my old system and all other functions are working normal. I have added to the address table with no problems--it has 1150 addresses in it. When I try to print labels, I am ask to "enter parameter value" for "trim". This request has not been asked previously. No matter what value keyed to this request, I receive a listing in 3-up label format of # ERROR for each line of each label. I have also used the label wizard to redo this report, but the results are the same. Another attempt using a Query as input for the report yeilds the same problem. I need expert help for this problem. Thanks for your experience |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Access 97 to 2002 problem | Harry J | General Discussion | 4 | July 15th, 2004 11:52 PM |
Trim error when using label wizard Access 2003 | randy | Setting Up & Running Reports | 2 | July 8th, 2004 05:15 PM |
printing problem | JIM.H. | General Discussion | 0 | June 28th, 2004 12:49 AM |
Need help with Access decision | aualias | General Discussion | 23 | June 21st, 2004 02:04 AM |
how to stop printer ejecting label sheet after printing 1 label | sardon | Setting Up & Running Reports | 0 | May 21st, 2004 09:21 PM |