If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Landscape VS Portrait printing problem
I try to print a report on a dot matrix printer (Tractor feed) from
access 97. It prints very well but I am unable to get it print the right side. My printer Form is 8½x11 (Horizontal) so look like landscape but is portrait for the printer. Unfortunately, if I want to reproduce the same form in access, I need to put the report landscape (portrait is not wide enough) but then it will print vertically on the printer. I need to have a portrait page setup in access that is 11 inch wide, 8½ high. I read in groups that it is possible to rotate label and text box with something on www.leblanc.com but it transform the text in some kind of picture. The printer I want to print to is an ASCII printer. There is also no custom size paper available in the printer's drivers. Any Ideas? The only solution I found is to print on A3 paper format, which is wide enough, but twice as high. It is ok to print 1 page but cannot print 2 or more in a row. |
#2
|
|||
|
|||
Landscape VS Portrait printing problem
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Printing multiple portait and landscape workbooks at the same time | Sbaitso | General Discussion | 7 | March 30th, 2005 05:49 PM |
VISIO printing problem in landscape | JimB | Visio | 1 | October 21st, 2004 08:19 PM |
Fixing header for landscape changes on portrait | Katherine | Formatting Long Documents | 1 | October 15th, 2004 06:44 PM |
combine portrait and landscape | Ynot | Powerpoint | 1 | October 8th, 2004 06:32 PM |
excel 2000 landscape printing | ChiragV | General Discussions | 0 | July 27th, 2004 06:23 PM |