If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Datasheet view
Is it possible to make the label in the datasheet view wrap itself?
I have a label that's very long and I would like it to wrap the words so that it's 2 lines instead of one. That way I can shrink the column down and still see the entire label. Is this possible? Thanks, Jasper |
#2
|
|||
|
|||
Datasheet view
Jasper
You've (re-)discovered one of the reasons folks tend to avoid the datasheet view. If you use a different view/form, you can do that easily. Regards Jeff Boyce Microsoft Office/Access MVP "Jasper Recto" wrote in message ... Is it possible to make the label in the datasheet view wrap itself? I have a label that's very long and I would like it to wrap the words so that it's 2 lines instead of one. That way I can shrink the column down and still see the entire label. Is this possible? Thanks, Jasper |
Thread Tools | |
Display Modes | |
|
|