If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Increasing resolution of a surface contour plot
I have data that needs to be plotted in a surface contour plot. The Z axis
is in percentage of the maximum value. The plot will only show the curves in 20% increments. I would like at least 10% resolution, better yet 5%. Is there any way to change how the plot is drawn to get these resolutions? |
Thread Tools | |
Display Modes | |
|
|