If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
pivot chart
I would like a pivot chart to not display the new data (as chart)
automatically immediately as you refresh the table new data entry receiving the data but gives us the opportunity when we want to choose to appear them in the chart. Not automatically bur manually to been seen (if we choose them) |
#2
|
|||
|
|||
pivot chart
Don't refresh (or auto-refresh on open) the Pivot Table/Chart then until you
want the new data displayed. If its a matter of adding a new series, you should be able to select only the series that you want to display from the dropdown. -- Best Regards, Luke M *Remember to click "yes" if this post helped you!* "george" wrote: I would like a pivot chart to not display the new data (as chart) automatically immediately as you refresh the table new data entry receiving the data but gives us the opportunity when we want to choose to appear them in the chart. Not automatically bur manually to been seen (if we choose them) |
Thread Tools | |
Display Modes | |
|
|