If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Visio 2003: sequence diagram, procedure call
I have 2 objects (mc:Controller and timer1:Timer) where Controller
sends a message (procedure call) to Timer. The procedure call is: wakeUpIn(7.4,mc) The message is displayed as: wakeUpIn:=wakeUpIn(7.4,mc) Is there a way to get rid of the first part (wakeUpIn:=) in order just "wakeUpIn(7.4,mc)" is displayed? |
Thread Tools | |
Display Modes | |
|
|