If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Preformed reports
I have my application running on 3 different places with 3 different printers
In the future my application will run in more than 10 places (or more), every place with their printer I am printing reports on predefined papers and in every place my application report must to be set on that particular printer I want to set some variables on my report and change those variables in every place instead to change the report every time The problem is how to change the position of one object in the report (“Top” and “Left” properties) with variables not manually? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Emailing PDF reports from Access | CraigMc | General Discussion | 6 | October 11th, 2007 12:52 AM |
Report Filter | ACase | Setting Up & Running Reports | 3 | October 27th, 2005 08:51 PM |
Some users cannot run reports | Frank | Setting Up & Running Reports | 11 | October 22nd, 2005 03:46 AM |
Print a series of reports based on a single date and a series of numbers | Bill R via AccessMonster.com | Setting Up & Running Reports | 1 | September 9th, 2005 12:53 AM |
REPOST: Maintaining Page Numbers with multiple reports. | Robin Chapple | Setting Up & Running Reports | 1 | August 5th, 2005 06:53 AM |