|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
October 28th, 2008, 05:50 PM
posted to microsoft.public.access
|
|||
|
|||
default open to Form only.
how do i use it so my form opens only and you have to hold the SHIFT key
while double clicking to get to the design? 
|
|
#2
October 28th, 2008, 06:18 PM
posted to microsoft.public.access
|
|||
|
|||
|
default open to Form only.
It varies slightly with different versions of Access, but generally you
go to Tools/Startup and from there you can choose a display form as well as enable/disable several other options. You hold down the shift key during startup to bypass these startup options. -- _________ Sean Bailey "Dennis Villareal" wrote: how do i use it so my form opens only and you have to hold the SHIFT key while double clicking to get to the design?
|
|
#3
October 28th, 2008, 06:26 PM
posted to microsoft.public.access
|
|||
|
|||
|
default open to Form only.
thanks for the quick response
"Beetle" wrote: It varies slightly with different versions of Access, but generally you go to Tools/Startup and from there you can choose a display form as well as enable/disable several other options. You hold down the shift key during startup to bypass these startup options. -- _________ Sean Bailey "Dennis Villareal" wrote: how do i use it so my form opens only and you have to hold the SHIFT key while double clicking to get to the design?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
