|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
November 8th, 2009, 11:54 PM
posted to microsoft.public.word.docmanagement
|
|||
|
|||
3 hole punch paper set margins
How do you set margins to fit 3 hole puched paper
|
|
#2
November 9th, 2009, 12:27 AM
posted to microsoft.public.word.docmanagement
|
|||
|
|||
|
3 hole punch paper set margins
Punches can vary a bit. If you allow about .75" you should be fine.
-- JoAnn Paules MVP Microsoft [Publisher] Tech Editor for "Microsoft Publisher 2007 For Dummies" "A. Basettt" A. wrote in message ... How do you set margins to fit 3 hole puched paper
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
