|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
June 19th, 2009, 01:04 AM
posted to microsoft.public.office.setup
|
|||
|
|||
Office 2007 Pro
I can't figure out how to make my scanner scan multiple pages. Scan stops
after first page and box pops up saying it needs to close the program. I have gone through the settings in the Scan New Document window one by one, changed them tried but didn't help. Has anyone had this problem before? 
|
|
#2
June 19th, 2009, 08:40 AM
posted to microsoft.public.office.setup
|
|||
|
|||
|
Office 2007 Pro
If you are using MS Document Scanning, initially run office diagnostics, see
if that helps. If not visit your scanner makers site and see if updated drivers or firmware are available. Configure MS Update for critical updates only and NOT driver updates "MaryS" wrote in message ... I can't figure out how to make my scanner scan multiple pages. Scan stops after first page and box pops up saying it needs to close the program. I have gone through the settings in the Scan New Document window one by one, changed them tried but didn't help. Has anyone had this problem before?
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
