If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Changing the page setup for printing
Hi there
Currently, when my report prints, it is in landscape. How can I change it so that it prints portrait and is reduced 75%? Is it possible to set this up in a macro? Thank you |
#2
|
|||
|
|||
Changing the page setup for printing
Open your report in design mode and then setup your layout and properties and
you want them to be. In your case goto Page Setup and change the page orientation to portrait. Then set your page content to fit within the page boudaries. Save your changes and then this is the way they will be from now on. -- Hope this helps, Daniel Pineault http://www.cardaconsultants.com/ For Access Tips and Examples: http://www.devhut.net Please rate this post using the vote buttons if it was helpful. "forest8" wrote: Hi there Currently, when my report prints, it is in landscape. How can I change it so that it prints portrait and is reduced 75%? Is it possible to set this up in a macro? Thank you |
#3
|
|||
|
|||
Changing the page setup for printing
Access does not support printing in reduced or enlarged mode.
You can redesign the report using smaller or larger fonts. As far as changing the orientation - open the report and use the page set up to change the orientation. A problem is that if you are printing landscape then you are probably going to end up printing a section of the right side of the current report on a separate page. The fix for that is to move controls around to keep the printing on one vertical page wide. John Spencer Access MVP 2002-2005, 2007-2010 The Hilltop Institute University of Maryland Baltimore County forest8 wrote: Hi there Currently, when my report prints, it is in landscape. How can I change it so that it prints portrait and is reduced 75%? Is it possible to set this up in a macro? Thank you |
Thread Tools | |
Display Modes | |
|
|