|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
September 1st, 2004, 07:47 PM
|
|||
|
|||
Info across two forms
I put info into form #1 and then through a buttom got to form #2. The curser
is nowhere on form # 2 untile I click the proper field. When I then go back to form #1 the same thin happens, the Curser is nowhere until I click. How can I get the curser to the proper field? 
|
|
#2
September 1st, 2004, 10:11 PM
|
|||
|
|||
|
In the OnOpen event of each form you need to put a
statement like the following: [Fieldname].setfocus -----Original Message----- I put info into form #1 and then through a buttom got to form #2. The curser is nowhere on form # 2 untile I click the proper field. When I then go back to form #1 the same thin happens, the Curser is nowhere until I click. How can I get the curser to the proper field? .
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Clicking on the form's datasheet view to display the info | Le | New Users | 1 | August 18th, 2004 10:32 PM |
| datasheet forms open in form mode from the Switchboard | Paul James | Using Forms | 5 | July 13th, 2004 06:51 AM |
| append query adding all records to table instead of one | Tony | Using Forms | 9 | July 10th, 2004 08:07 AM |
| Populate two+ fields on a Form, based on a pop up form's record | Michael Miller | Using Forms | 0 | June 9th, 2004 02:56 PM |
| Carrying over info in my forms? | Jolene | New Users | 3 | May 22nd, 2004 07:12 PM |
Linear Mode
