If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
How do I get my tool bar (task bar) in word to remain displayed?
TWO QUESTIONS - IN MICROSOFT 7 I CAN'T FIGURE OUT HOW TO GET THE TOOL BAR, OR
TASK BAR, AT THE TOP OF THE WINDOW TO STAY DISPLAYED. I HAVE TO CLICK ON VIEW OR HOME TO GET IT TO COME UP AND THEN CHOOSE AN OPTION BUT AS SOON AS I BEGIN TO TYPE MY REPORT, THE TOOL BAR DISAPPEARS. ALSO, HOW DO I CHANGE MY SPACING FROM DOUBLE TO SINGLE TO 1 1/2? THANK YOU TO ANYONE THAT CAN PROVIDE HELP WITH THESE TWO QUESTIONS! DEBBY |
#2
|
|||
|
|||
How do I get my tool bar (task bar) in word to remain displayed?
Block capitals are considered shouting in web forums and newsgroups. Such
shouting is not only unwelcome but is also very difficult to read. There is no such product as Microsoft 7. The nearest would be the new Windows 7 operating system, but as you are asking in a Word forum I assume you must mean Word 2007? Word 7 would be something entirely different. It may not always be possible to answer your questions if you don't correctly identify the product you are asking about. In Word 2007, to get the tabs to remain displayed *double* click the tabs of click the small arrow at the right end of the QAT (Quick Access Toolbar) and uncheck 'Minimize the Ribbon' Spacing is a paragraph formatting setting of the current style. Either modify that style of create a new one that provides the format you require. However, if you are used to earlier versions of Word, you may consider setting the style set (Home Tab) to Word 2003. -- Graham Mayor - Word MVP My web site www.gmayor.com Word MVP web site http://word.mvps.org DEBBY wrote: TWO QUESTIONS - IN MICROSOFT 7 I CAN'T FIGURE OUT HOW TO GET THE TOOL BAR, OR TASK BAR, AT THE TOP OF THE WINDOW TO STAY DISPLAYED. I HAVE TO CLICK ON VIEW OR HOME TO GET IT TO COME UP AND THEN CHOOSE AN OPTION BUT AS SOON AS I BEGIN TO TYPE MY REPORT, THE TOOL BAR DISAPPEARS. ALSO, HOW DO I CHANGE MY SPACING FROM DOUBLE TO SINGLE TO 1 1/2? THANK YOU TO ANYONE THAT CAN PROVIDE HELP WITH THESE TWO QUESTIONS! DEBBY |
Thread Tools | |
Display Modes | |
|
|