If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Lines appear to have different weights
Hey,
I'm working on a table that has been converted from .pdf using AbbyFine 8.0 to MS Word. I have checked the table to be sure that the shading was changed from "white" to "no fill". I have removed all my borders, changed the line weight to 1/2, highlighted my entire table and applied the border around all of the cells. Afterwards, I removed the few lines that I don't want. My problem is when I create the .pdf (using Adobe 8.0 standard and the print quality and setting at 600dpi to resolve other issues with the lines on tables appearing and disappearing depending on the view percentage) only the heading section of my table has line weights that are noticeably different. I am optimistic that there is a "fix" or correction for my methods that will allow these table lines to be uniform. Thank you, -- Michele |
#2
|
|||
|
|||
Lines appear to have different weights
I have noticed this as well in the past, at the time I put it down to the
Header Row of the table included Bold formatting and this "confused" the conversion. I either took of the Bold or increased the line weight for the whole table to 1pt, which seemed to correct the problem. Is this document going out for professional printing? Because 600dpi is quite high, have you tried lower settings? Best of luck DeanH "Michele" wrote: Hey, I'm working on a table that has been converted from .pdf using AbbyFine 8.0 to MS Word. I have checked the table to be sure that the shading was changed from "white" to "no fill". I have removed all my borders, changed the line weight to 1/2, highlighted my entire table and applied the border around all of the cells. Afterwards, I removed the few lines that I don't want. My problem is when I create the .pdf (using Adobe 8.0 standard and the print quality and setting at 600dpi to resolve other issues with the lines on tables appearing and disappearing depending on the view percentage) only the heading section of my table has line weights that are noticeably different. I am optimistic that there is a "fix" or correction for my methods that will allow these table lines to be uniform. Thank you, -- Michele |
Thread Tools | |
Display Modes | |
|
|