If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
word2003: ruler does not extend to entire width of the page
In print layout view, the ruler (including the dark gray page margins on the
left and right ) is approximately 2cm shorter (on the right-hand side) than the actual page width. This leads to the effective right page margin being approx. 2cm wider than defined in page setup. The document is 20 pages, contains bullets, automatically generated index, no images. Please help! thanks, Mark P.S. This post is similar to the following message which does not contain a solution to the problem: http://support.microsoft.com/newsgro...a-09fd97012e1e |
#2
|
|||
|
|||
Hi =?Utf-8?B?UGxhbmV0ZWVy?=,
In print layout view, the ruler (including the dark gray page margins on the left and right ) is approximately 2cm shorter (on the right-hand side) than the actual page width. This leads to the effective right page margin being approx. 2cm wider than defined in page setup. The document is 20 pages, contains bullets, automatically generated index, no images. Is it possible that Track Changes is activated in the document, and that what you're seeing is the extra area Word adds in order to display "balloons"? If you go to Tools/Options/Track Changes and set the display of the "balloons" to "Never" does the extra area go away? If it does, then display the Reviewing toolbar and turn OFF the change tracking. Then accept/reject any changes accumulated in the document. Cindy Meister INTER-Solutions, Switzerland http://homepage.swissonline.ch/cindymeister (last update Jun 8 2004) http://www.word.mvps.org This reply is posted in the Newsgroup; please post any follow question or reply in the newsgroup and not by e-mail :-) |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Two-column report needs info across the page header width | Dan | Setting Up & Running Reports | 1 | October 18th, 2004 09:44 PM |
New page for subreport | Stephen | Setting Up & Running Reports | 1 | September 13th, 2004 06:12 PM |
Excel Worksheets | Richard | General Discussion | 2 | July 8th, 2004 04:34 AM |
NUMBERING the pages | Bob | New Users | 7 | June 14th, 2004 12:20 AM |