|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
March 19th, 2005, 02:53 PM
|
|||
|
|||
Detect & repair does not work
Office was installed with software version 1.0 and this PC now employs a
later version of this software, 1.1. When MS Word is excuted, the resulting message tells me to run Detect & Repair. Running Detect & Repair tells me that the source is unavailable. The installation source for this product is not available. Verify that the source exists and that you can access it. 
|
|
#2
March 19th, 2005, 03:17 PM
|
|||
|
|||
|
Source unavailable wrote:
|| Office was installed with software version 1.0 and this PC now || employs a later version of this software, 1.1. When MS Word is || excuted, the resulting message tells me to run Detect & Repair. || || Running Detect & Repair tells me that the source is unavailable. || || The installation source for this product is not available. Verify || that the source exists and that you can access it. Put your Office installation CD in the CD drive? -- Interim Systems and Management Accounting Gordon Burgess-Parker Director www.gbpcomputing.co.uk
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| how do I create a work order form | cher952 | Using Forms | 1 | March 14th, 2005 05:09 PM |
| Problem With Nested Joins | Don | Running & Setting Up Queries | 8 | February 26th, 2005 09:04 PM |
| Calendars in OL2003/OL2000 | Rich | General Discussion | 16 | February 10th, 2005 12:41 AM |
| Detect and repair... | Phillip | Formatting Long Documents | 1 | December 1st, 2004 08:16 AM |
| "Work Offline" Menu and "Exit" Menu | MSHUME | General Discussion | 1 | September 27th, 2004 09:17 PM |
Linear Mode
