If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Table Line Width
Please help! I spend so much time clicking on Borders and Shading and then
changing the line width to 1-1/2 pts. Is there any way to make the 1-1/2 line width my default line width instead of the 1/2 pt that is set up now??? Thanks, Lisa |
#2
|
|||
|
|||
Table Line Width
In any given Word session (or document) the selected width remains the
default until you change it. This applies to the Borders toolbar flyout palette on the Formatting and Tables and Borders toolbars. -- Suzanne S. Barnhill Microsoft MVP (Word) Words into Type Fairhope, Alabama USA Word MVP FAQ site: http://word.mvps.org Email cannot be acknowledged; please post all follow-ups to the newsgroup so all may benefit. "Lisa D." Lisa wrote in message ... Please help! I spend so much time clicking on Borders and Shading and then changing the line width to 1-1/2 pts. Is there any way to make the 1-1/2 line width my default line width instead of the 1/2 pt that is set up now??? Thanks, Lisa |
#3
|
|||
|
|||
Table Line Width
You can use a macro to change the line width. Via the link below, you will
find a macro that applies the same table borders to all tables in the active document: http://thedoctools.com/index.php?show=mt_tableborder Note that in order to apply a line width of 1 1/2 pt, you need to change the following code line in the macro: oBorderWidth = wdLineWidth050pt to oBorderWidth = wdLineWidth150pt -- Regards Lene Fredborg DocTools - Denmark www.thedoctools.com Document automation - add-ins, macros and templates for Microsoft Word "Lisa D." wrote: Please help! I spend so much time clicking on Borders and Shading and then changing the line width to 1-1/2 pts. Is there any way to make the 1-1/2 line width my default line width instead of the 1/2 pt that is set up now??? Thanks, Lisa |
Thread Tools | |
Display Modes | |
|
|