If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Jump to a specific record?
Hi
When I have opened up my form I want to jump to a specific record. Is this possible, and how? Do I have to use some magic RunCommand constants ?? |
#2
|
|||
|
|||
Jump to a specific record?
If you only want a specific Record in the Form's RecordSource, check the
WhereCondition argument of the OpenForm Method. If you want the Form's RecordSource to have all rows unfiltered, then use the OpenArgs argument of the OpenForm Method to pass the value that identifies the Record you want and use this in the Form_Load (or Form_Open) Event to navigate to the required Record. Check Access VB Help on the WhereCondition argument and the OpenArgs argument odf the OpenForm Method. -- HTH Van T. Dinh MVP (Access) wrote in message ... Hi When I have opened up my form I want to jump to a specific record. Is this possible, and how? Do I have to use some magic RunCommand constants ?? |
Thread Tools | |
Display Modes | |
|
|