If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Bar Graph (Waterfall) Chart
Hello,
Profits in $ are shown in the Y axis (left hand side) The bar chart will go up or down based on the Profit $ amounts. Products A, B, C etc. are on the X axis. The third item to be shown in chart are Volumn in units. How do I make the each of the bars widen according to the number of units? This type of chart has been named "waterfall" chart, but I couldn't get the Chart Wizard to come up with anything similar to it. Thanks in advance, Ricky |
#2
|
|||
|
|||
Bar Graph (Waterfall) Chart
Hi
have a look at http://www.tushar-mehta.com/excel/ch...fall/index.htm http://peltiertech.com/Excel/Charts/...ies.html#Falls -- Regards Frank Kabel Frankfurt, Germany "Ricky" schrieb im Newsbeitrag ... Hello, Profits in $ are shown in the Y axis (left hand side) The bar chart will go up or down based on the Profit $ amounts. Products A, B, C etc. are on the X axis. The third item to be shown in chart are Volumn in units. How do I make the each of the bars widen according to the number of units? This type of chart has been named "waterfall" chart, but I couldn't get the Chart Wizard to come up with anything similar to it. Thanks in advance, Ricky |
#3
|
|||
|
|||
Bar Graph (Waterfall) Chart
Hi Frank,
Thanks for the links. I've gone through both sites and have found some helpful information about waterfall charts. However, I still can't get the bars to widen based on a 3rd criteria. I could get the bars to show the profit $ on the Y axis, the Products on the X axis...I just can't get the 3rd part (Units) to be represented by width of each bar. Thanks again, Ricky "Frank Kabel" wrote in message ... Hi have a look at http://www.tushar-mehta.com/excel/ch...fall/index.htm http://peltiertech.com/Excel/Charts/...ies.html#Falls -- Regards Frank Kabel Frankfurt, Germany "Ricky" schrieb im Newsbeitrag ... Hello, Profits in $ are shown in the Y axis (left hand side) The bar chart will go up or down based on the Profit $ amounts. Products A, B, C etc. are on the X axis. The third item to be shown in chart are Volumn in units. How do I make the each of the bars widen according to the number of units? This type of chart has been named "waterfall" chart, but I couldn't get the Chart Wizard to come up with anything similar to it. Thanks in advance, Ricky |
Thread Tools | |
Display Modes | |
|
|